MicronPC CM900 Guía de usuario descargar pdf (Pagina 7)

To connect the power cord to your monitor and a power source, use the

following instructions:

Caution: If the AC outlet is not grounded (with three holes), install the

proper grounding adapter (not supplied).

1 Plug the power cord into your monitor’s power input socket. See Figure 3

for the socket’s location.

Figure 3: Connecting Cables

2 Plug the other end of the power cord into a three-pin AC power outlet or

a UL-approved power strip.

Video Cable

The monitor comes with the video cable built into the monitor. To connect

the video cable’s connector to your computer’s video port, complete the

following steps:

Caution: Do not bend the signal cable excessively, or you might

break the wires inside the cable.

1 Plug the video cable's 15-pin connector (see Figure 3) into the

computer's video port. Be careful not to bend any pins on the connector.

2 Tighten the two screws on the video connector with your fingers to

secure the connection.

Caution: Over-tightening this connection can damage the monitor

cable or your computer’s video card.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Sin comentarios

MicronPC CM900 Guía de usuario Pagina 7